Automobile Flame Tail Pipe

Unless I was willing to cut some length off my pipe, I had to jerry rig this to make it work on my SR5. The end of the SR5 is 2 3/4" wide and although you can slip on this extension over it, you can only do so with only one of the washers on the inside. I literally installed this with a one bolt and washer. I just bought a stainless steel (so it wouldn't rust) nut of the same diameter, but the shortest I could buy (so it did not stick out obnoxiously), put it on the least visible side of the extension, and then used some Loctite Blue. Have had it on through the car wash and stayed on just fine. ALSO, I wanted the black version, but if you look at pictures the black comes off quickly. Even on this one, there are pictures of it rusting. Therefore, I sprayed some Rustoleum clear enamel on it to protect it. I think it is going to last a long time for me. I may periodically recoat it.

It took me 5 minutes to install it, and as you see in the picture it looks amazing On my 2014 Honda Odyssey Ex-l I have to say Im very very impress with the quality is a good looking, and it gives the car a different look tbh, something small but very elegant, thank you for your business

I don't consider these easy to install for most, seeing as for the best sound you'll want them welded on completely. They will give a more deep throaty tone than just a normal non-resonated tip ever will. On a 5.7 challenger I took the rear mufflers and replaced them with for of these, cruising noise level is close to if not the same as stock, not as loud but much cleaner sounding than just a muffler delete.